Technical specifications of equipment for monitoring waves and surface sea water temperature in Vietnam
What are regulations on technical specifications of equipment for monitoring waves and surface sea water temperature in Vietnam?
Technical specifications of wave monitoring equipment in Vietnam
Pursuant to Section II.2.3 National Technical Regulations on oceanographic monitoring issued together with Circular 08/2021/TT-BTNMT Technical specifications of wave monitoring equipment are as follows:
2.3.1. Technical specifications of wave monitoring equipment are specified in Table 5.
Table 5. Specifications of wave monitoring equipment
No |
Content |
Symbol |
Unit of measure |
Measuring range |
Resolution |
Measurement error |
1 |
Wave height |
H |
Meter (m) |
0 to 20 |
0.005 m |
± 10 % |
2 |
Wave propagation direction |
Angle degree ( o ), compass direction |
0 to 360 |
Automatic 1o, manual 22,5o |
± 10 o |
|
3 |
Wave length |
λ |
Meter (m) |
0 to 200 |
0.1 |
± 1 (m) |
4 |
Wave cycle |
Second(s) |
0 to 20 |
0.1 |
± 0.1 (s) |
|
5 |
Wave transmission speed |
C |
Meter/second (m/s) |
0 to 20 |
± 1 % |
2.3.2. Regulations for monitoring wave types and symbols are in Table 6.
Table 6. Wave type
No |
Wave type |
Symbol |
1 |
Waves |
G |
2 |
Rogue waves |
L |
3 |
Waves/rogue waves |
G/L |
4 |
Rogue waves from two different directions |
L/L |
5 |
Rogue waves/waves |
L/G |
6 |
Waveless |
- |
2.3.3. Waveform monitoring regulations and symbols are in table 7
Table 7. Waveforms
No |
Wave |
Symbol |
1 |
Rolling waves |
LT |
2 |
Regular waves |
D |
3 |
Waves are uneven |
KD |
2.3.4. Regulations for monitoring estimated wave heights and recording methods are in Table 8
Table 8. Wave height
No |
Altitude (m) |
How to record |
1 |
0.00 |
0.00 |
2 |
0 |
0.20 |
3 |
From 0.25 to 1.50 |
0.25; 0.50; 0.75; 1.00; 1.25; 1.50 |
4 |
From 2.00 to 4.00 |
2.00; 2.50; 3.00; 3.50; 4.00 |
5 |
From 4.50 and up |
Rounding to the nearest meter: 5.00; 6.00; 7.00; ... |
2.3.5. Regulations for monitoring wave propagation direction and symbols are in Table 9.
Table 9. Wave propagation direction
No |
Wave propagation direction |
Symbol |
Wave propagation direction |
Symbol |
1 |
Northeast |
NE |
Southwest |
SW |
2 |
East |
E |
West |
W |
3 |
South East |
SE |
northwest |
NW |
4 |
South |
S |
North |
N |
The direction of wave propagation is automatically measured by the machine in degrees of angle (o) from 0 to 360.
2.3.6. Regulations for monitoring sea surface state in Table 10.
Table 10. Determination of sea surface status level
No |
Signs identifying sea surface status |
Grant |
1 |
The water surface is as smooth as a mirror |
0 |
2 |
The water surface shook, rippling very thick waves |
1 |
3 |
When the wave falls, there is only foam as clear as glass |
2 |
4 |
Silver waves appear in some places on the sea surface |
3 |
5 |
When the front of the wave falls, there is white foam. The white foam spreads down the entire side of the wave and appears everywhere on the sea surface |
4 |
6 |
When the front of the wave falls, there is white foam, the foam spreads down the side of the wave, the base of the wave creates large pieces of foam that shoot up onto the sea surface and are found everywhere. |
5 |
7 |
When white foam covers both sides of the wave, creating a large white patch that shoots up on the sea surface, long wave blades are seen everywhere. |
6 |
8 |
When there is a storm, white waves cover almost the entire sea surface, and water foam shoots high |
7 |
9 |
The entire sea surface is covered with white foam, the wind blows away the tops of the waves, and in the air there is water spray and water droplets flying with the wind, corresponding to when there is a big storm. |
8 |
10 |
The entire sea surface was covered with white foam, the air was full of spray and water droplets, visibility was greatly reduced, and the storm was very big. |
9 |
Technical specifications of equipment for monitoring waves and surface sea water temperature in Vietnam (Image from the Internet)
Technical specifications of surface sea water temperature monitoring equipment in Vietnqam
Pursuant to Section II.2.4 National Technical Regulations on oceanographic monitoring issued together with Circular 08/2021/TT-BTNMT, the technical specifications of the surface seawater temperature monitoring device are as follows:
Unit of measurement: degrees Celsius ( oC)
Measuring range: from 0 to 50 oC
Resolution: 0.2 oC
Measurement error: ± 0.1 oC
Best regards!